Grass Valley JEP Series v.1.3.0 - Manual (Page 81)

JEP Series — Installation Manual 81
Locking or Unlocking an Output
This function allows breakaway operation during which the selected
Levels remain selected after a TAKE. For example, you may want to keep
switching different video test signals to a destination but not switch audio
tone. To turn on sticky mode:
1. MENU - ON.
2. Use UP/DOWN to step to "S.M. on?"
3. Press the TAKE button. Sticky mode is now active.
4. Perform a breakaway switch
The breakaway pattern of this switch will remain in effect after the
TAKE command is executed (and also if
CLEAR is selected).
For example, if Sticky mode is on, and the operator makes a video-only
switch, the next switch will also be video only unless specified other-
wise. In other words, as long as Sticky mode is on the last-selected
breakaway settings will persist.
To find out which levels are sticky, press the TAKE button and then UP/DOWN .
The Level window will show the levels that will switch. If the Level buttons
have been assigned, the appropriate buttons will illuminate.
To cancel sticky levels, press MENU, and then use UP/DOWN to toggle the
display to "S.M off?" Then press the TAKE button.
M.O. - Multiple Output Mode On/Off
This function allows "gang" switching where the same input is switched to
multiple outputs with a single TAKE command. The following procedure
assumes that destination buttons have been assigned.
To turn on Multiple Output mode:
1. MENU - ON.
2. Use UP/DOWN to step to "M.O. on?"
3. Press the TAKE button. Multiple Output mode is now active.
4. Toggle on/off the outputs that you want to switch.
5. Select the preferred input.
6. Press the TAKE button. The input will be switched to all selected outputs.
The breakaway pattern of subsequent switches will remain in effect
after the TAKE command is executed (and also if CLEAR is selected).
To cancel multiple output mode press MENU, then use UP/DOWN to toggle
the display to "M.O. off?" Then press the TAKE button.