Grass Valley K2 Summit 3G v.8.0 - Manual (Page 101)

Front interconnect board removal
Before doing this task, remove the front bezel assembly and disk controller board.
1. To remove the front interconnect board, proceed as illustrated.
Slide out
Remove screw 1
2
2. When installing, do the following:
a) Make sure the board engages with the top and bottom guides.
b) Make sure the board engages with the connector on the midplane board.
mSATA boot media removal
Before doing this task, remove the front bezel assembly, disk controller board, and front interconnect
board.
1. To remove the boot media, work on the front interconnect board as illustrated.
Remove 2 screws 1
Disengage 2
Use a #1 Phillips screwdriver to remove the screws.
The mounting mechanism is spring loaded and the mSATA media pops up when screws are
removed.
You must use the mSATA boot media provided by Grass Valley. Do not use media procured
elsewhere.
2. When installing, hold down the mSATA media to align for fastening screws.
02 February 2012 K2 Summit 3G Production Client Service Manual 101
Removing and replacing FRUs