Grass Valley K2 Summit 3G v.8.0 - Manual (Page 56)

6. Proceed as follows:
• If all the names on this system are configured correctly to locations, skip the rest of this
procedure.
• If names on this system are not configured correctly to locations, for each adapter name
incorrectly configured, complete the remaining steps of this procedure.
7. Select the name in the Name column.
8. Select File | Rename to enter rename mode.
9. Type the name required for the location.
Next, proceed as follows:
• If network configuration is complete, enable the write filter.
• If continuing with network configuration, your next task is to create the Control Team.
Create the Control Team
Before beginning this task, make sure of the following:
• Adapters are named
NOTE: Team control ports only. Do not team media ports.
1. If K2 software is installed, disable the write filter, if it is not already disabled.
2. In Device Manager, right-click the adapter name that on this system is assigned to location PCI
bus 4, device 0, function 1.
3. Select Properties
The Properties dialog box opens.
56 K2 Summit 3G Production Client Service Manual 02 February 2012
Service procedures