Grass Valley K2 Summit 3G v.8.0 - Manual (Page 64)

Comments Startup Type Status Service
— Manual Started Sabretooth License Server
— Manual — Sabretooth Protocol Service
Checking pre-installed software
Software is pre-installed on K2 products when you receive them from the factory. This load of
pre-installed software is referred to as the “golden drive”. The following list is an example of the
software pre-installed. Check "K2 Release Notes" for the most up-to-date list with version
information.
If you suspect that pre-installed software is not correct, use the recovery process to re-load the
software. Do not attempt to un-install, install, or repair pre-installed software without guidance from
your Grass Valley Support representative.
K2 Summit system pre-installed software
• Intel Pro Software
• QuickTime
• Microsoft iSCSI Initiator
• MS XML
• .NET Framework
• MegaRAID — Do not use this utility on a K2 Summit system. This utility is for use by qualified
Grass Valley Service personnel only. When this utility is opened it scans the SCSI bus and
interferes with record and play operations.
• J2SE Runtime Environment
• StorNext software
• Windows PowerShell
• Windows XP Embedded
Making CMOS settings
NOTE: This procedure is intended for use by Grass Valley Service personnel or under the direct
supervision of Grass Valley Service personnel.
1. Connect keyboard, monitor, and mouse to the K2 Summit system.
2. Restart the K2 Summit system.
3. During the BIOS startup screen, watch the keyboard lights (capslock, numlock, etc.). When the
lights flash, press Delete to enter Setup.
4. Press F3 and then press Enter . This loads optimal default values for all the setup questions.
5. Press F4 and then press Enter to save settings and restart.
Restoring disk controller configuration
Do this task when replacing the disk controller board.
64 K2 Summit 3G Production Client Service Manual 02 February 2012
Service procedures