Grass Valley K2 Summit 3G v.8.0 - Manual (Page 75)

5. On the Welcome page, click Next .
6. On the Backup Archive Selection page, in the tree view expand the node for Removable Disk (D:)
and select the image file, then click Next .
7. On the Restoration Type Selection page, select Restore disks or partitions and then click Next .
8. On the Partition or Disk to Restore page, select MBR and Track 0 and then click Next .
9. On the Disk Selection page, select Disk 1 and then click Next .
NOTE: Verify capacity to make sure you select the boot media card. It has an interface
identified as "IDE (0) Primary Master".
10. On the Next Selection page, select Yes, I want to restore another partition or hard disk drive and
then click Next .
11. On the Partition or Disk to Restore page, select (C:) and then click Next .
12. On the Restored Partitions Resizing page, select Yes, I want to resize partitions and then click
Next .
13. On the Restored Location page, select (C:) and then click Next .
NOTE: Verify capacity to make sure you select the boot media card (CompactFlash or mSATA)
and not a media drive. The boot media has a much smaller capacity and has an interface
identified as "IDE (0) Primary Master".
14. On the Restored Partition Type page, select Active and then click Next .
15. Do one of the following:
• If the Restored Partition Size page does not appear. Skip ahead to the Next Selection page.
• If the Restored Partition Size page appears. Continue with the next step.
16. On the Restored Partition Size page, do one of the following:
• If Free space after reports 0 bytes, leave settings as they are. Click Next .
• If Free space after does not report 0 bytes, increase Partition size until Free space after reports
0 bytes. Click Next .
17. On the Next Selection page, select No, I do not and then click Next .
18. On the Restoration Options page, do not make any selections. Click Next .
19. On the “…ready to proceed…” page, verify that you are restoring the correct image to the correct
location. Click Proceed .
20. On the Operation Progress page, observe the progress report.
21. When a “The data was successfully restored” message appears, click OK .
22. Click Operations | Exit to exit the Acronis True Image program.
The machine restarts automatically.
23. Remove the recovery media while the machine is shutting down.
24. Upon startup, wait for initialization processes to complete. This can take several minutes, during
which time USB keyboard/mouse input is not operational. Do not attempt to shutdown or
otherwise interfere with initialization processes.
After startup, one or more device discovery windows can open. Allow processes to complete
without interference. If a Fibre Channel card driver, ignore until instructed later in this process.
02 February 2012 K2 Summit 3G Production Client Service Manual 75
Service procedures