Grass Valley K2 Summit 3G v.8.0 - Manual (Page 72)

Next, check the adapter names and order. If adapter names and order are not as documented, restore
network configuration.
Related Topics
Reorder adapters on page 60
Restoring network configuration on page 52
Restoring to blank mSATA
This task is for a K2 Summit 3G system that has had its mSATA boot media replaced with a new
blank mSATA card. This means the mSATA card has never been initialized and has never before
contained a disk image.
You can use this task to restore from a system-specific image or from a generic image. This task
provides instructions for accessing an image on the Recovery Flash Drive. If you access an image
from a different location, such as a network connected drive or another connected USB drive, alter
the steps in this task as appropriate. There can be multiple versions of the generic recovery disk
image on the Recovery Flash Drive. Refer to related topics in "K2 Release Notes" to determine
which version you should use.
NOTE: If restoring using a generic image, the K2 Summit system is returned to its factory
default condition. Passwords and other site-specific configurations are reset to factory defaults.
1. Make sure that media access is stopped and that the system on which you are working is not
being used.
2. If you have not already done so, connect keyboard, monitor, and mouse.
3. Do the following:
a) Insert the Recovery Flash Drive into a USB port.
b) Restart the machine, or power on if currently shut down.
The machine boots from the Recovery Flash Drive, into a version of Windows stored on the
drive.
A MS-DOS command window opens.
c) When prompted with a list of options, type 2 to select the Acronis option and then press Enter .
The Acronis program loads.
4. In the Acronis main window, click Recovery .
The Restore Data Wizard opens.
5. On the Welcome page, click Next .
6. On the Backup Archive Selection page, in the tree view expand the node for Removable Disk (D:)
and select the image file, then click Next .
7. On the Restoration Type Selection page, select Restore disks or partitions and then click Next .
8. On the Partition or Disk to Restore page, select MBR and Track 0 and then click Next .
9. On the Disk Selection page, select Disk 1 and then click Next .
NOTE: Verify capacity to make sure you select the boot media card. It has an interface
identified as "IDE (0) Primary Master".
10. On the Next Selection page, select Yes, I want to restore another partition or hard disk drive and
then click Next .
11. On the Partition or Disk to Restore page, select (C:) and then click Next .
72 K2 Summit 3G Production Client Service Manual 02 February 2012
Service procedures