Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 166)

166 KARRERA — Installation & Service Manual
Section 5 — Basic Configuration
Configure Control Surfaces
1. Touch Eng Setup , Node Settings , Control Surfaces , and enter the IP address
and name the control surface you are adding. Assign it to Suite 2 Surface
A . If you are using an additional Menu Panel or PC for that suite, you
can change it to Suite 2 Surface A at this time as well ( Figure 112 ).
Figure 112. Control Surface Menu with Suite 2 PC and Panel
2. Touch Reset Panel . This will re-establish system communications. After
reboot the Status Menu will report the added control surface
(
Figure 113 ).