Grass Valley Karrera Video Production Center Installation v.4.1 - Manual (Page 226)

226 KARRERA — Installation & Service Manual
Section 7 — Maintenance
Reset Procedures
Video Processor Frame Reset
A Video Processor Frame reset button is located near the center of the front
edge of the Controller Board, accessed by opening the front door of the
Frame (
Figure 163 ). The 8-RU and 4-RU Frames use the same type of Con-
troller Board. Pressing this button will reset both the Video Processor CPU
and the Image Store Processor CPU. Powering the unit off and back on also
resets the Video Processor Frame.
Figure 163. 4-RU Video Processor Frame Reset Button and Power Switch
Control Panel Reset
The Karrera Control Panel can be reset in IP address mode using that
panel’s EMEM area buttons, or by cycling power to the unit.
1. On any EMEM area, press Menu , Page . This shows a list of menu items
that are selected with the buttons below the display ( Figure 167 , left).
Figure 164. Karrera IP Address Mode Selection, EMEM Area
ON OFF
Controller Board Power Switch Reset Button
8623266
67
Me Menu
Pause Pause 9 Bank ank
3 / 7
7 8 Lrn
Menu 1
Trans
Rate
Stripe
Delg
Panel
Mem
Macro
Me Menu
Pause Pause 9 Bank ank
3 / 7
7 8 Lrn
Menu 2
Panel
Saver IP
Addr
Calib Time Date
8804_06