HEIDENHAIN TNC 620 (340 56x-01) - Manual (Page 223)

HEIDENHAIN TNC 620 223
8.2 Cy
cles f
o
r Dr
illing, T
apping and Thr
ead Milling
8.2 Cycles for Drilling, Tapping and
Thread Milling
Overview
Cycle Soft key Page
240 CENTERING
With automatic pre-positioning, 2nd set-
up clearance, optional entry of the
centering diameter or centering depth 225
200 DRILLING
With automatic pre-positioning, 2nd set-
up clearance 227
201 REAMING
With automatic pre-positioning, 2nd set-
up clearance 229
202 BORING
With automatic pre-positioning, 2nd set-
up clearance 231
203 UNIVERSAL DRILLING
With automatic pre-positioning, 2nd set-
up clearance, chip breaking, and
decrementing 233
204 BACK BORING
With automatic pre-positioning, 2nd set-
up clearance 235
205 UNIVERSAL PECKING
With automatic pre-positioning, 2nd set-
up clearance, chip breaking, and
advanced stop distance 237
208 BORE MILLING
With automatic pre-positioning, 2nd set-
up clearance 240
206 TAPPING NEW
With a floating tap holder, with automatic
pre-positioning, 2nd set-up clearance 242
207 RIGID TAPPING NEW
Without a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance 244
209 TAPPING W/ CHIP BREAKING
Without a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance, chip breaking 246