Yaskawa 1000 Series Drive Option - CANopen Installation - Manual (Page 18)

5 Installation Procedure
18 YASKAWA ELECTRIC TOBP C730600 45B 1000-Series Option SI-S3 Installation Manual
◆
Installing the Option Card
1.
Shut off power to the drive, wait the appropriate amount of time for voltage to
dissipate, then remove the operator and front cover. Refer to the drive technical
manual for direction on removing the front cover.
2.
Insert the CN5 connector on the option card into the CN5-A connector on the drive,
then fasten it into place using one of the screws included with the option card.
Connect the ground lead line to the ground terminal using one of the screws
delivered with the option card.
Note: There are only two screw holes on the drive for ground terminals. If three option cards are
connected, two of the lead lines will need to share the same ground terminal.
Figure 5
Figure 5 Installing the Option Card
A – Insert connector CN5 here G – Lead line
B – Option card H – Drive grounding terminal (FE)
C – Front cover I – Connector CN5-A
D – Operator J – Connector CN5-B
E – LED label K – Connector CN5-C
F – Use wire cutters to create an
opening for cable lines
G
K
A
B
D
J
I
H
F
ERR RUN E
C