Yaskawa 1000 Series Drive Option - Profibus-DP Installation - Manual (Page 31)

8 Troubleshooting
YASKAWA ELECTRIC TOBP C730600 42C 1000-Series Option SI-P3 Installation Manual 31
Digital Operator Display Fault Name
oFA00
Non-Compatible Option connected to drive port CN5-A
Option is not properly connected.
Cause Possible Solution
Non-compatible option
connected to drive port CN5-A Use only compatible options. Connect the SI-P3 to CN5-A. For other option
connections, refer to the Installation Manual for those options.
Digital Operator Display Fault Name
oFA01
Option Fault (CN5-A)
Option is not properly connected.
Cause Possible Solution
Problem with the connector
between the drive and option.
Turn the power off and check the connectors between the drive and option.
Digital Operator Display Fault Name
to oFA30 to
oFA43
Option Fault (CN5-A)
Communication ID error.
Cause Possible Solution
Option hardware fault. Replace the option. Contact Yaskawa for assistance.
Digital Operator Display Fault Name
oFb00
Non-Compatible Option connected to drive port CN5-B
Non-compatible option is connected.
Cause Possible Solution
Non-compatible option
connected to drive port CN5-B. Use only compatible options. Connect the SI-P3 to CN5-A. For other option
connections, refer to the Installation Manual for those options.
Digital Operator Display Fault Name
oFb02
Option Fault (CN5-B)
Two of the same option are connected simultaneously.
Cause Possible Solution
Options AI-A3 or D1-A3
connected to the CN5-B port
while an option was connected
to CN5-A.
Only one of these options, AI-A3, DI-A3 or SI-†† option can be connected to the
drive at the same time. The SI-N3 must be connected to CN5-A.
Digital Operator Display Fault Name
oFc00
Non-Compatible Option connected to drive port CN5-C
Non-compatible option is connected.
Cause Possible Solution
Non-compatible option
connected to drive port CN5-C. Use only compatible options. Connect the SI-P3 to CN5-A. For other option
connections, refer to the Installation Manual for those options.