5 installation procedure – Yaskawa EtherNet/IP User Manual
Page 18
Advertising
A
C
NS
MS
Figure 4 Apply the LED Label
3.
Make sure the screws on the left and right sides of the option terminal block (J) are
tightened with a tightening torque of 0.5 to 0.6 Nm (4.4 to 5.3 in lbs), then insert the
option (B) into the CN5-A connector (L) located on the drive and fasten it using one
of the included screws (H).
NS MS
K
L
F
M
TX RX
Figure 5 Insert the Option
5 Installation Procedure
18
YASKAWA TOEP YAICOM 16A 1000-Series Option Dual-Port EtherNet/IP SI-EN3D Installation Manual
Advertising