Yaskawa Modbus TCP/IP SI-EM3D - Manual (Page 18)

A
C
NS MS
Figure 4 Apply the LED Label
3.
Make sure the screws on the left and right sides of the option terminal block (J) are
tightened with a tightening torque of 0.5 to 0.6 Nm (4.4 to 5.3 in lbs), then insert the
option (B) into the CN5-A connector (L) located on the drive and fasten it using one
of the included screws (H).
NS MS
K
L
F
M
TX RX
Figure 5 Insert the Option
5 Installation Procedure
18 YASKAWA TOEP YAICOM 18A 1000-Series Option Dual-Port Modbus TCP/IP SI-EM3D Installation Manual