Yaskawa GPD506/P5 with Apogee FLN Option - Manual (Page 20)

19
4.4.3 Stop Running
In this mode, Cable Loss Timeout (#92) is set to the desired interval and Cable Loss Frequency (#91) is
set to 0. If the time between messages exceeds the timeout interval, the drive’s frequency command
(#60) is set to 0 and the run command (#24) is set to ‘Off’. Cable Loss Fault (#90) must be ‘Disabled’.
4.4.4 Fault
In this mode, Cable Loss Timeout (#92) is set to the desired interval and Cable Loss Fault (#90) is set to
‘Enable’. If the time between messages exceeds the timeout interval, an ‘EF0’ fault is declared and the
drive stops. Cable Loss Frequency (#91) is ignored.