LeMond g-force RT - Manual (Page 12)

12
3.5.1 Body
1. Fold down the sides of the carton base and
remove the packing material from around the
bike.
2. Leave the body of the bike on the carton base
while the remaining assembly is completed.
CAUTION: Remove the staples completely to
avoid injury.
3.5.2 Front Stabilizer
1. Locate the front stabilizer and the unattached wheel. The front stabilizer already has one wheel
attached.
2. Slide the front stabilizer into place at the front of the body frame from the left side. Rotate the
stabilizer until the set screw is positioned into the alignment notch. This will align the attach-
ment screw holes of the body and the front stabilizer. Be careful not to dislocate the plastic
sleeve at the opposite side of the tubing. If the sleeve is pushed out of place, remove the stabi-
lizer, replace the sleeve and reinstall the stabilizer.
3. Secure the front stabilizer by sliding star washers onto each of (2) M8x30 screws and tightening
with the 6mm hex wrench.
4. Slide the remaining front wheel onto the end of the front stabilizer and attach the wheel cap.
Use the alignment pins as a guide to install the wheel cap correctly.
5. Secure the wheel cap to the wheel with (2) self-tapping screws and tighten with the 3mm
wrench.
3 ASSEMBLY AND INSTALLATION INSTRUCTIONS