LeMond g-force RT - Manual (Page 14)

14
Attaching the Display Console to the Console Mast
Battery Installation
CAUTION: Never use conventional alkaline batteries. You will damage your electronic parts
and void your warranty.
The display console of the g•force RT is powered by (4) rechargeable AA nickel-metal hydride (Ni-MH)
batteries, which are included. You provide the power to recharge the batteries by simply pedaling and
working out on your bike.
1. Remove the battery compartment cover on the back of the display by pressing down on the tab
and then lifting the cover off. An illustration at the bottom of the battery compartment indi-
cates the correct positioning of the batteries.
2. Place the batteries into the compartment as indicated on the illustration. Insert the negative
end into position first and then gently push the positive end into place.
3. Replace the battery compartment cover.
Note: Your batteries will not be fully charged when
your bike arrives. You will need to pedal for at least 1
hour to fully charge the batteries.
Attaching the Display Console
1. Connect the wires from the console mast to
the wires on the back of the display console.
2. Once connected, gently feed the wiring into
the console mast until the display console
can rest snugly against the platform. The
platform of the console mast should fit
completely inside the grooved section of
the back of the display console.
3. Attach the display console to the console
mast using (4) M5x15 screws and tighten
with the 3mm hex wrench.
3 ASSEMBLY AND INSTALLATION INSTRUCTIONS