LeMond g-force RT - Manual (Page 18)

18
Attaching the Pedals to the
Crank Arms
1. Before attaching the pedals to
the cranks apply multipurpose
grease to the threads of each
pedal. Pedals that are not suf-
ficiently lubricated will often
make a squeaking or clicking
noise with every pedal rotation
which can become an annoy-
ance.
2. Attach the left pedal (marked L)
to the left crank. Tighten with
the pedal wrench in a COUN-
TER-CLOCKWISE direction.
3. Attach the right pedal (marked R) to the right crank. Tighten with the pedal wrench in a CLOCK-
WISE direction.
The cranks of the g•force RT have 9/16-20 threads, making the bike compatible with all standard pedal
systems, including the LeMond® Dual-sided Indoor Cycling Pedal.
3.5.7 Cup Holders
1. Place one cup holder in each bend of the handlebars. The cup holders are marked as left (L) or
right (R) on the underside of the holder.
2. Attach the cup holders with (4) M6x15 screws and tighten with the 4mm hex wrench.
3.6 Leveling the g•force RT
Now that the bike is fully assembled, carefully lift the rear end, and roll the bike to its final location.
Check the stability of the bike by attempting to rock it from side to side. If the bike rocks or wobbles, it
should be leveled. A bike that is leveled correctly will provide a more stable and comfortable ride.
The two feet of the rear stabilizer can be adjusted to compensate for uneven floors. To level the bike,
simply raise or lower the two leveling feet by screwing them in or out as needed.
3 ASSEMBLY AND INSTALLATION INSTRUCTIONS