Casio XW-G1 - Manual (Page 82)

Other Useful Functions
E-80
■ Part 01 through Part 16 Settings
■ External Input Part Settings
■ Master Settings
Mixer Settings
Display Description Settings
Part
Part on/off. Turns each part on or off. This is the same parameter that is turned on and off by the 4
1 to 16 buttons (page E-79).
Off, On
Tone
Part tone. This is the tone of each part.
While this item is selected, you can select a tone using the same operation as that used in the Tone
Mode.
• A tone with DSP will have DSP next to the tone name on the display (page E-37). Part 01:
Solo Synth P000 to
PCM Drum U309
Part 02 to 16:
PCM Tone P100 to
PCM Drum U309
Volume Part volume. This is the volume of each part. 0 to 127
Pan Part panning. Adjusts the left-right position of sound in the stereo field. –64 to 0 to +63
CoarseTune Part coarse tune. Shifts the pitch of notes by semitone units. –12 to 0 to +12
FineTune Part fine tune. Shifts the pitch of notes by cent units. –99 to 0 to +99
BendRange
Part bend range. Specifies (in semitone units) the maximum change in pitch when the bt BENDER
wheel is rotated.
–24 to 0 to +24
DSP Line Part DSP line. Specifies whether DSP (page E-36) is applied to the notes of each part. Off, On
Rev Send Part reverb send. Controls how the reverb effect (page E-36) is applied to each part. 0 to 127
Cho Send Part chorus send. Controls how the chorus effect (page E-36) is applied to each part. 0 to 127
Display Description Settings
Part
Same as “Part 01 through Part 16 Settings” (page E-80).
Volume
Pan
DSP Line
Rev Send
Cho Send
N.Thresh
Noise gate threshold. Reduces noise by cutting all input sound at a volume that is smaller than this
setting value.
0 to 127
N.Release
Noise gate release. Time that input sound is cut after its volume drops below the noise gate threshold
value.
0 to 127
Auto Level
Auto level control. Automatically adjusts the input signal level. The greater the setting value, the stronger
the effect.
Off, 1 to 3
Display Description Settings
Volume Master volume. Adjusts the volume of all the parts. 0 to 127
Pan Master panning. Adjusts the left-right position of sound in the stereo field of all the parts. –64 to 0 to +63