Kichler 337010 Dual Slider Control - Manual

1. Safety PrecautionS:
Warning: To avoid fire, shock and serious personal injury,
follow all instructions carefully. Read your owner’s manual
carefully before installing the ceiling fan control. Retain
owner’s manual for future reference.
2. To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box or circuit breaker panel
before wiring.
3. This control is designed to operate only one ceiling fan.
note: This fan slider control is rated for 1.25 amps at
120 volts. If your ceiling fan is equipped with a variable
speed pull chain switch control, make sure to set it
at the highest speed before installing the fan slider control.
This will avoid erratic speeds and possible damage to
your ceiling fan.
4. Make certain no bare wires are exposed outside the connectors.
5. All wiring must conform to National and Local Electrical
Codes. If you feel you do not have enough electrical
wiring knowledge or experience, have your fan/light
dual slider control installed by a licensed electrician.
Any electrical work not described in this manual should be
performed by a licensed electrician.
6. Use of this control with some ceiling fans could result in
fire, shock and serious personal injury. Use this fan control
only with capacitor speed controlled ceiling fans.
inStallation
note: Installation of this control requires that the three-con-
ductor cable with ground wire be run between the control wall
box and the ceiling fan outlet.
1. After electricity has been turned off at the main fuse box or
circuit breaker panel, remove the existing wall plate and
switch.
2. Proceed to make the wire connections as follows; (make
sure the fan and light slide switches of the wall control are
set in the “OFF” position ). Connect the solid black wire
from the wall control the black wire from the fan. Connect
the blue wire from the dual slider control to the red
or blue wire from the fan. Connect the black with the
stripe wire from the wall control to the 120v AC hot wire.
Use wire connectors provided to secure the connections.
note: If your outlet box has a ground wire (green or bare
copper), connect the wall transmitter’s ground wire to the outlet
box ground wire. If your outlet box does not have a ground wire,
connect the wall transmitter’s ground wire directly to one of the
screws from the outlet box.
note: Refer to schematic on back of wall control.
3. Secure the dual slider control to the outlet box using the
two 6-32” x 3/4” screws provided.
4. Secure the face plate over the dual slider control with the
two 6-32” x 1/4” screws provided.
inStallation and oPerating inStructionS
for fan/light dual Slider control
Warning!
Shut PoWer off at fuSe or circuit breaker.
6-32" x 3/4"
SCREWS
6-32" x 1/4"
SCREWS
BLACK
BLACK
BLUE
BLUE
BLACK BLACK
WHITE
AC 120V INPUT
BLACK WHITE
WHITE
GREEN
TO GROUND
BLA
CK/
WHITE
BLA
CK
BLA
CK
FAN
FIG. 1
Warning!
hook uP “in SerieS” only
Do not connect to hot and common wire of electric circuit
or switch will be damaged. Refer to Fig. 1.
Date Issued: 8/8/08 IS-337010-US
BLA
CK/
WHITE
BLUE
BLUE
GREEN
TO
GR
OUND
BLACK