Installation and assembly – MCZ Flair User Manual
Page 26
24
6-INSTALLATION AND ASSEMBLY
The air can be channelled by fastening a flexible pipe on the rear part of the product with a clamp, in line with the hole on the upper part.
The air can now be released from the front and rear, only from the front or only from the rear.
These channels can also be walled in (SEE OPTIONALS).
Room ventilation can only be set towards the rear wall if there is adequate insulated ducting of the hot air flow.
The air outlet pipe can become very hot, approx. 200°C: therefore, it must be adequately insulated with suitable
material, especially points that could come in contact with flammable surfaces or parts that are affected by heat
(e.g. change in shades, wiring ducts, plasterboard, etc.). Moreover, persons and animals must be protected from
accidental or intentional contact. In any case, comply with the regulations and laws in force in the region where the
product is installed.
FAN 2 TURNED FOR REAR AIR.
FAN 2 ORIGINAL POS.