MCZ Flair - Manual (Page 30)

b
b
c
c
c
c
b
b
A
e
28
6-INSTALLATION AND ASSEMBLY
ASSEMBLING THE SERPENTINE SIDE PANELS
The product is supplied with the serpentine panels packaged separately, therefore unpack all the parts before proceeding with the
assembly.
Follow the sequence below to assemble the panels:
• Flaps “b” on the lower part of the stone panel A must be fitted into the holes of the structure of the stove. Then fasten the panel to
the structure - pos.c - with the screws and nuts supplied (two screws at the top).
IMPORTANT!
The “A” and “B” serpentine panels are not interchangeable: panel “A” goes only at the bottom and panel “B” only at
the top. The panels are recognisable as there are two flaps protruding from the serpentine in the upper part of panel
“A”, whereas upper panel “B”, has two flaps in line with the serpentine stone. (see figure next page).