MCZ Flair - Manual (Page 51)

49
10-MAINTENANCE AND CLEANING
Technical Dept. - All rights reserved - Reproduction is prohibited
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specific detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass spray cleaner on the painted parts or the door gaskets
(ceramic fibre cord).
PERIODIC CLEANING PERFORMED BY A QUALIFIED TECHNICIAN
CLEANING THE HEAT EXCHANGER
The compartment through which the exhaust smoke passes must be cleaned at the of the winter season.
This cleaning process is mandatory in order to facilitate the general removal of all combustion residue, before it becomes very difficult to
remove it due to the humidity compacting it over time.
If necessary, clean it more often.
It is good practice to guarantee effective ventilation in the room while cleaning the product.
CLEANING THE EXCHANGER:
When the stove is cold, open the door, remove pan “M” and brazier “N”; remove the side plates “O” and “P” by turning them slightly
inwards for them to come out of their grooves and then pull them towards you (be careful as they can break easily).
Once the side plates are removed, lift plate “H” slightly, tilt it downwards and remove it.
Then remove the upper plate “Q” by inserting the cold handle or another tool in slot “Y” on the upper part and lifting plate “Q”. Remove it
from its seat by lifting it and then tilting it slightly downwards.
Scrape the walls of the firebox with a rigid rod or a bottle brush into plate “Q” that has just been removed, for the ash to fall into the lower
ash collection compartment.
Once the upper exchanger is cleaned, remove plate “L” after having removed the two screws, and use the nozzle of a vacuum cleaner to
remove the ash and soot accumulated in the lower exchanger and around brazier “N”. Clean and reassemble everything.