MCZ Flair - Manual (Page 29)

d
d
e
d
f
f
B
27
6-INSTALLATION AND ASSEMBLY
Technical Dept. - All rights reserved - Reproduction is prohibited
• Panel B can be fastened by following the procedures implemented to assemble panel A. The flaps on the lower part of the panel -
pos. d - must enter the holes in the structure, whereas two screws on the upper part of the panel, block it to the structure - pos. f.
Panel B rests on the two adjustable screws “e”. Panels A and B could touch or the gap between may be too wide, therefore, adjust
screw “e” to resolve the problem.
•
IMPORTANT!
The “A” and “B” ceramic panels are interchangeable as both the ceramic and metal support are the same.
CERAMIC PANELS (INSIDE VIEW)
A/B = TOP OR BOTTOM PANEL