MCZ Flair - Manual (Page 34)

32
6-INSTALLATION AND ASSEMBLY
ASSEMBLING THE AIR FILTER
The cylindrical filter is already fitted inside the product.
If it must be cleaned, slightly loosen the screw knob on the air inlet pipe, remove the filter, clean it and then set it and block it in place by
tightening the knob.
ATTENTION!
The stove must never be operated without the air filter. The manufacturer cannot be held liable for any damage
caused to the internal components if this requirement is not complied with.
OPENING/CLOSING THE DOOR
ATTENTION!
The door must be closed properly for the product to work correctly.
The door of the Flat/Flair stove is opened by inserting the cold handle on the opening hook of the door, lifting and pulling.
ELECTRICAL CONNECTION
First connect the power cable to the back of the product and then to a wall socket.
The main switch at the side must only be activated when the stove is used; otherwise, it is advisable to keep it off.
It is recommended to disconnect the power cable when the product is not used.
ASSEMBLING/REMOVING THE AIR FILTER.
OPENING THE DOOR.
ELECTRICAL CONNECTION
I/O SWITCH CONNECTION OF THE POWER
CABLE TO THE STOVE