Emergency panel – MCZ Flair User Manual
Page 43
41
8-EMERGENCY PANEL
Technical Dept. - All rights reserved - Reproduction is prohibited
EMERGENCY PANEL
There is an emergency panel on the product side, designed for any malfunction to be detected and product control if the remote control
should malfunction.
KEY
A
Three-digit display that indicates a variety of product information besides the identification code of any malfunction.
B
GREEN LED that indicates:
•
OFF= The product is off.
•
FLASHING ON= The product is starting up.
•
FIXED ON= The product is on.
C
RED LED that indicates:
•
OFF= The product is on.
•
ON AND FLASHING SLOWLY= The product is shutting down.
•
ON AND FLASHING QUICKLY= The product is in alarm status (accompanied by a buzzer for the first 10 minutes).
•
FIXED ON= The product is off.
D
3-position selector for the following functions:
•
OFF= The product is switched off manually without the remote control.
•
REMOTE= The product can only be controlled via remote control.
•
ON= The product is switched on manually without the remote control.
E
3-position selector for the power selection:
•
MIN= The product runs at MINIMUM power without the remote control and with selector 4 set to ON.
•
MED= The product runs at MEDIUM power without the remote control and with selector 4 set to ON.
•
MAX= The product runs at MAXIMUM power without the remote control and with selector 4 set to ON.
F
Button for diagnostic functions regarding the product operation mode.
G
Button to connect the product to a new remote control.
SELECTOR “D” MUST BE SET TO THE “REMOTE” POSITION FOR THE PRODUCT TO BE REMOTE CONTROLLED.