Rose Electronics Vista Remote 2 - Manual (Page 14)

UNIT CONFIGURATION
8 Vista Remote 2 Installation and Operations Manual
Configuring the Vista Remote 2 IP Input module
When you locally connect to Vista Remote 2 unit for the first time the Unit and Network must
be configured. Follow the recommended procedure below to configure all models:
Make all cable connections to the KVM station, network, and computers
Apply power to all devices (Computers, Vista Remote 2, and Monitor).
Make sure a computer is connected to CPU port #1 and that computer is powered on.
If no computer is connected to port #1, the OSD menu screens may not sync.
With power applied, a standard login screen will display on the KVM monitor
Login on to the unit using the default user ID, admin and no password
After a successful login, the remote computer’s video will display on the KVM monitor.
Press the CTRL + ALT + C keys simultaneously to display the configuration menu options
as shown below: (Unit connection screen may display after initial connection is made)
Figure 5. Configuration OSD
Select “Unit Configuration” and the below screen will display
Figure 6. Unit Configuration OSD