TA Triumph-Adler FAX 940 - Manual (Page 44)

Setting your machine
3-9
Op
eration
Se
tting y
o
ur
mac
h
ine
Getting started
Directory
M
a
intenance
Safety
Contents
Installation
Date en cours : 24 mars 2003
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFL-MFC-MFK\MFL 251 259 240A_LU FAX LASER PRO 343SMS_345SMS Sagem
GB\Setting your machine.fm
/
2&$/
$
5($
1
(7:25.
 /$1 
6(77,1*6

'(3(1',1*

21

02'(/
Your terminal is a new generation machine that will be part of your local network just like a PC.
Its built-in local network access card will enable you to send documents through an SMTP/POP3
local message server (internally or externally, depending on the settings of your message server).
To benefit from all the available network options, you should make the following settings,
described in the sections below:
• local network settings, to introduce your fax machine into your local network.
• message service settings, for all your faxes and E-mails to be automatically managed by
your message server.
Caution - Although rather simple, network settings sometimes require a sound knowledge of
your own computer configuration. If that is administrated by anyone in your company, we
recommend you ask that person for the settings described below.
/
2&$/

1(7:25.

6(77,1*6
$XWRPDWLFFRQILJXUDWLRQ
We recommend that you carry out a manual configuration of your terminal. The automatic
configuration of the local network settings may be considered, if your local network features a
DHCP or BOOTP server that can dynamically assign addresses to the peripheral devices present
on the LAN.
To automatically configure the local network settings:
M 261 OK - SETUP / LOCAL NETWORK / CONFIGURATIO
+
Choose AUTOMATIC and press OK to confirm. The terminal scans the local network for a
DHCP or BOOTP server that can assign it its settings dynamically (the
message
SELF-CONF is displayed).
+
Once the message SELF-CONF has disappeared, check for the IP Address, Sub-network
mask and Gateway address. If these are missing, you should carry out a manual
configuration (see below).
0DQXDOFRQILJXUDWLRQ
To configure your terminal manually, you should obtain the usual information used to set a
peripheral device (IP address, sub-network mask, network and gateway address).
To configure the local network setting manually:
M 261 OK - SETUP / LOCAL NETWORK / CONFIGURATIO
+
Choose MANUAL , and press OK to confirm.
MFL 251 259 240A_MF34 Sagem Gb.book Page 9 Lundi, 24. mars 2003 2:50 14