TA Triumph-Adler FAX 940 - Manual (Page 97)

6-16
Maintenance
Date en cours : 24 mars 2003
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFL-MFC-MFK\MFL 251 259 240A_LU FAX LASER PRO 343SMS_345SMS Sagem
GB\Maintenance Gb.fm
• restarting the transmission using the transmission queue refer to paragraph Immediately perform
transmission from the waiting queue, page 5-8). In this case, for a document composed of
several pages, the transmission will take place from the page where the error occurred
• abandoning the transmission by deleting the corresponding command in the transmission line
(refer to paragraph Deleting a transmission on hold, page 5-8)
The fax machine makes at most 5 automatic redials. The non-transmitted document is automatically
deleted from the memory and a transmission report is then printed together with an error code and the
cause for transmission failure (see the communication error codes).
&RPPXQLFDWLRQHUURUFRGHV
The communication error codes appear in the logs and transmission reports.
*HQHUDOFRGHV
Code 01 - Busy or no fax answer
This code appears after 6 unsatisfactory attempts. Call later.
Code 03 - User break
A communication has been stopped by the user pressing the key .
Code 04 - Non programmed number
A number saved as a one-touch key or abbreviated number is not valid-check it. (Example: a delayed
transmission was programmed with a one-touch key and this key has been deleted in the meantime).
Code 05 - Scanning default
An incident occurred with the scanner, for example, the sheet is jammed.
Code 06 - Printer default
An incident occurred in the printer: no paper, paper jam, opened cover... In the reception mode, this
incident appears only if the reception parameter is switched to
WITHOUT PAPER (refer to paragraph
Reception without paper, page 3-5).
Code 07 - Disconnected
The link has been cut (bad line). Check the number and try again.
Code 08 - Quality
The document you sent was not well received. Contact your subscriber to see if you need to send again.
Code 0A - No document to be polled
You tried to poll a document from a subscriber who had not prepared his document (no deposit) or the
password entered was incorrect.
Code 0B - Wrong number of pages
There is a difference between the number of pages indicated during preparation for the transmission
and the number of pages sent- check the number of pages in the document.
Code 0C - Received document error
Ask the subscriber who called you to check the length of his document (it may be too long to be
completely received).
Code 0D - Transmission failed
Ask the sender to resend the document.
MFL 251 259 240A_MF34 Sagem Gb.book Page 16 Lundi, 24. mars 2003 2:50 14