TA Triumph-Adler 3005ci - Manual (Page 468)

10-20
Troubleshooting > Troubleshooting
2 or more sheets are
overlaps when ejected.
(multi feed) ― Load the paper correctly. page 3-18
page 3-26
Printouts are wrinkled. Are the originals loaded correctly? Load the paper correctly. page 3-18
page 3-26
― Clean the paper separator. page 10-4
― Turn the orientation 180 degrees around
in which the paper is positioned. page xv
page 3-18
page 3-26
Is the paper damp? Replace the paper with new paper. page 3-16
Printouts are curled. ― Turn the paper over in the cassette, or
turn the orientation 180 degrees around
in which the paper is positioned. page xv
page 3-18
page 3-26
Is the paper damp? Replace the paper with new paper. page 3-16
Is the paper printed out to the finisher? Change the [Correct Paper Curl]. page 8-59
Cannot print. Is the machine plugged in? Plug the power cord into an AC outlet. ―
Is the machine powered on? Turn on the main power switch. page 2-10
Are the printer cable and network cable
connected? Connect the correct printer cable and
network cable securely. page 2-6
Was the machine powered on before the
printer cable was connected? Power on the machine after connecting
the printer cable. ―
Is the print job paused? Resume printing. page 7-4
Cannot print with USB
memory.
USB memory not
recognized. Is the USB host blocked? Select [Unblock] in the USB host
settings. page 8-50
― Check that the USB memory is securely
plugged into the machine. ―
Printouts have vertical lines. Are the slit glass and the Dual scanning
area dirty? Clean the slit glass and the Dual
scanning area. page 10-3
― Run [Laser Scanner Cleaning]. page 10-43
Dirt on the top edge or back
of the paper. Check the machine interior. Open the right cover. If the machine
interior is dirty with toner, clean it using
soft, dry, lint-free cloth. ―
Symptom Checkpoints Corrective Actions
Reference
Page