Enterasys Networks Security Router X-PeditionTM - Manual (Page 244)

Answering Incoming ISDN Calls
10-22 Configuring Dialer Services
Node B (Called Node) Configuration
The following commands add two users to validate calls made from Node A. This configuration
employs the username/authentication method of mapping incoming calls.
XSR(config)#username toronto privilege 0 password cleartext z
XSR(config)#username boston privilege 0 password cleartext y
These commands add a dialer pool member and set the Central Office switch type on BRI port 1/
0:
XSR(config)#interface bri 1/0
XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3
XSR(config-if<BRI-1/0>)#dialer pool-member 22
XSR(config-if<BRI-1/0>)#no shutdown
The following commands configure Dialer inter 0 on BRI interface 1/0:
XSR(config)#interface dialer 0
XSR(config-if<D0>)encapsulation ppp
XSR(config-if<D0>)ppp authentication pap
The following commands add a dialer pool and map BRI interface 1/0 to Dialer interface 1. The
dialer called command maps incoming Node A calls to Node B’s 2400 number. Optionally,
you can employ the dialer caller method and specify a PPP authenticated username to map
incoming calls.
XSR(config)#interface dialer 1
XSR(config-if<D1>)#no shutdown
XSR(config-if<D1>)dialer pool 22
XSR(config-if<D1>)encapsulation ppp
XSR(config-if<D1>)dialer called 2400
! dialer caller 2300
! dialer remote-name toronto
XSR(config-if<D1>)ip address 10.10.10.2 255.255.255.0
The following commands add a dialer pool and map BRI interface 1/0 to Dialer interface 2. The
dialer called command maps incoming Node A calls to Node B’s 2400 number. Optionally,
you can employ the dialer caller method and specify a PPP authenticated username to map
incoming calls.
XSR(config)#interface dialer 2
XSR(config-if<D2>)#no shutdown
XSR(config-if<D2>)#dialer pool 22
XSR(config-if<D2>)#dialer called 2400
! dialer caller 2600
! dialer remote-name boston
XSR(config-if<D2>)#encapsulation ppp
XSR(config-if<D2>)#ip address 20.20.20.2 255.255.255.0
The following command shuts down the SNMP server to avoid saving extraneous messages:
XSR(config)#snmp-server disable
Node D (Calling Node) Configuration
These commands add a dialer pool member and set the Central Office switch type on BRI port 1/
0:
XSR(config)#interface bri 1/0
XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3