Enterasys Networks Security Router X-PeditionTM - Manual (Page 435)

System Alarms and Events
XSR User’s Guide A-13
SYNC_
DRIV Packets lost > 255 (RX overrun) Sum of packets lost due to RX FIFO overrun exceeded 255.
PP Out of memory - frame dropped at port <port
number> Frame is dropped at the specified port from depleted memory.
PLATF Need 'snmp-server system-shutdown' for SNMP
reboot SNMP configuration does not allow reboots.
FR Serial a/b:d.e, packet arrived on unconfigured
DLCI nnnn Data is discarded
ETH1_
DRIV Recoverable error FastEthernet 2 chip (of the interface) has experienced a
significant but recoverable problem. The interface has already
corrected the problem by resetting itself.
ETH1_
DRIV Packets lost > 255 (RX overrun) Sum of packets this interface has lost (discarded) due to RX
FIFO overrun exceeds 255. This alarm will occur only once.
ETH0_
DRIV Recoverable error FastEthernet 1 chip (of the interface) has experienced a
significant, but recoverable problem. The interface has already
corrected the problem by resetting itself.
ETH0_
DRIV Packets lost > 255 (RX overrun) Sum of packets this interface has lost (discarded) due to RX
FIFO overrun exceeding 255. This alarm will occur once only.
CLI Login failed from address <IP address> due
to timeout Timeout error during login.
ASYNC_
IDRIV Recoverable error The device has hard recoverable error.
ASYNC_
IDRIV Packets lost > 255 (RX overrun) Sum of packets lost due to RX FIFO overrun exceeded 255.
FR Serial a/b:d unconfigured DLCI nn reported
active by LMI UNI-DCE has announced a DLCI as active but is not yet
configured on the XSR. The DLCI should be configured, if
required.
FR Serial a/b:d Fragmentation not configured for
DLCI nn - FRF.12 Packet received. The remote side of the connection is sending FRF.12 packets,
but the XSR is not configured locally to transmit FRF.12
packets. Any voice traffic may experience unnecessary delays.
FR Serial a/b:d clock lost - speed detected nn bps Frame Relay has detected a clock that is too slow and is
bringing the interface operationally down until the clock
reappears. If this problem persists, you may want to check the
attached equipment or contact the service provider.
FR Serial a/b:d clock recovered - speed detected nn
bps Frame Relay has detected a proper clock and is bringing the
interface operationally up. LMI should re-establish shortly
thereafter and DLCIS will start to pass traffic.
SERIAL Serial a/b - DSR Down CTS Up (MUX_DOWN) Serial port has detected an EIA transition which will cause an
interface down condition. This alarm is additional to the high
severity Interface <interface name>, changed state to down}
SERIAL Serial a/b - DSR/CTS Down (MUX_DOWN) Serial port has detected an EIA transition which will cause an
interface down condition. This alarm is additional to the high
severity Interface <interface name>, changed state to down}
Table A-8 Low Severity Alarms/Events (continued)
Module Message Description