Enterasys Networks Security Router X-PeditionTM - Manual (Page 280)

ISDN (ITU Standard Q.931) Call Status Cause Codes
11-16 Configuring Integrated Services Digital Network
XSR(config-if<BRI-1/1>)#no shutdown
XSR(config-if<BRI-1/1>)#dialer pool-member 1 priority 1
BRI Leased Line
The following example configures a leased-line BRI connection:
XSR(config)#interface bri 1/0
XSR(config-if<BRI-1/0>)#leased-line 64
XSR(config-if<BRI-1/0>)#leased-line 64
XSR(config-if<BRI-1/0>)#no shutdown
BRI Leased PPP
The following example configures a leased PPP connection on a BRI link:
XSR(config)#interface bri 1/0:2
XSR(config-if<BRI-1/0:2>)#no shutdown
XSR(config-if<BRI-1/0:2>)#encapsulation ppp
XSR(config-if<BRI-1/0:2>)#ip address 10.10.10.11 255.255.255.0
XSR(config-if<BRI-1/0:2>)#ppp keepalive
BRI Leased Frame Relay
The following example configures Frame Relay service over a multipoint leased BRI connection.
For more information on Frame Relay, refer to
“Configuring Frame Relay” on page 9-1.
XSR(config)#interface bri 1/0:1
XSR(config-if<BRI-1/0:1>)#no shutdown
XSR(config-if<BRI-1/0:1>)#encapsulation frame-relay
XSR(config-if<BRI-1/0:1>)#frame-relay lmi-type none
XSR(config)#interface bri 1/0:1.1 multi-point
XSR(config-if<BRI-1/0:1>)#ip address 2.2.2.2 255.255.255.0
XSR(config-if<BRI-1/0:1>)#frame-relay interface-dlci 16
XSR(config-if<BRI-1/0:1-16>)#no shutdown
ISDN (ITU Standard Q.931) Call Status Cause Codes
The XSR supports the Q.931 cause codes shown in the table below. Those codes marked with an
asterisk (*) are decoded into text by ISDN debugging. All other codes display a plus sign (+).
Table 11-2 Call Status Cause Codes
Code Cause
0 Valid cause code not yet received
1 Unallocated (unassigned) number
2 No route to specified transit network (WAN)
3 No route to destination
4 Send special information tone/Channel unacceptable
5 Misdialed trunk prefix
6 Channel unacceptable