Amprobe ACDC-620T Clamp-On-Multimeter - Manual (Page 16)

Figure 6. Push bottons
15
1. Press to lselect
DC.AC,DC+AC
Press and hold for
more than 1 second
to toggle, between
PEAK" and DC.
Press to toggle 0
and Temperature
measurements.
5. Press to toggle Continuity
ON/OFF for Ohm measurement.
Press to select T1-T2-T2 for tem
perature measurement.
3. Press and hold for more
than 1 second to set
Dynamic Recording then
press to step through
MAX,MIN, AVG and present
readings..
6. In manual range press to step
up 1 range at a time. Press
and hold for 1 sec to select
Auto range.
4. Press to toggle the relative
(ZERO) mode ON/OFF.
2. Press to toggle
"DH" ON/OFF.