Amprobe ACDC-620T Clamp-On-Multimeter - Manual (Page 62)

61
MAINTENANCE
WARNING
To avoid electrical shock, do not perform any servicing unless you are qualified to
do so.
c SERVICE
If the instrument fails to operate, check battery, test leads, etc. and replace as nec-
essary. If the instrument still does not operate, double check operating procedure as
described in this instruction manual. When servicing, use only specified replace-
ment parts.
WARNING
To avoid electrical shock or damage to the meter, do not get water inside the case.
Remove the test leads and any input signals before opening the case.
0 BATTERYREPLACEMENT
The meter is powered by a single 9V battery, with
NEDA1604, S006P,IEC6F22 carbon-zinc alkaline, or
similar battery. Replace battery if the low battery sign
(~)is displayed and flashing. Use the following procedure
to replace the baftery:
1 . Remove the meter from the circuit and turn the rotary
switch to the OFF position.
2. Disconnect the test leads from the instrument.
3 Loosen the screw on the battery cover.
4. Pull the cover up slightly and slide the battery cover off (see Figure 26 and
Figure 27).
5. Replace the defective battery.
6. Reverse the procedure of opening cover to close the
battery cover.