Amprobe ACDC-620T Clamp-On-Multimeter User Manual
Page 20
SPECIALFUNCTIONS INSTRUCTIONS
This clamp-on multimeter provides the operator with various functions including:
c
Dynamic Recording
c
Data Hold
c
Zero (Relative)
c
Analog bargraph
c
Auto Power Off and Sleep Mode
c
Disable Auto Power Off
c
Demonstrate Annunciator of Display
c
Continuity Function For Ohms Measurement
c
1ms Peak hold
c
DYNAMIC RECORDING
The dynamic recording mode can be used to catch intermittent and turn on or off
surges, verify performance while you are away, or take readings while you are
operating the equipment under test and can not watch the meter.
the average reading is useful for smoothing out unstable or changing inputs, esti-
mating the the percent of time a circuit is operational, or verifying circuit perform-
ance
The operational procedures are described below::
1. Press and hold the "MAX
●
MIN" push button to toggle recording mode on or
off. the dynamic recording ode is indicated when the MAX AVG MIN annunci
ator turns on. The present valve is stored to memories of maximum, minimum
and average.
2. Press this button momentarily to cycle through maximum, average and present
readings. The MAX, MIN, AVG annunciator turns on respectively to indicate
what value is being displayed. See Figure 7.
19