Amprobe DMIII-Multitest Power-Quality-Recorder - Manual (Page 26)

AMPROBE
DMIII MULTITEST
EN-24
6.2.3. Results of "TMR" mode
 At the end of the test if
the Insulation
resistance is lower
than R
MAX
(see Table2)
and the instrument
generated
the
Nominal test Voltage,
the instrument emits a
double
beep
indicating the positive
outcome of the test
and displays a screen
similar to the screen to
the right.
M  05.06.01 Insulation Resistance
1.07
M

514V 15s
TMR 500V TIME:60s
Voltage during the Test
Duration of the Test
Test mode
FUNC VNOM 
The displayed result can be stored by pressing the SAVE key twice (according to
paragraph 9.1).
 If
the Insulation
resistance is higher
than R
MAX
(see Table2),
the instrument emits a
double beep at the end
of the test indicating
the positive outcome
of the test and displays
a screen similar to the
screen to the right.
M  05.06.01 Maximum resistance value
that can be measured
(999

is displayed if a
rated voltage of 500V was
selected, see Table2). > 999
M

523V 15s
TMR 500V TIME:60s
The symbol ">" means that
the resistance value is
higher than R
MAX
.
Test duration
FUNC VNOM  
The displayed result can be stored pressing the SAVE key twice (according to
paragraph 9.1).