5 about the symcd.sys driver, 1 features, 2 description – Avago Technologies LSI20160 User Manual

Page 144: About the symcd.sys driver, Features, Description

Advertising
background image

6-18

DOS Device Driver Installation

Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.

The device driver does not recognize one of the nonboot SCSI
peripherals (system may lock up).

•

Make sure the drivers were installed in the correct sequence.

•

Make sure the drivers’ entries in the

CONFIG.SYS

file have the correct

path to the drivers.

•

Power down all units in the system.

•

Make sure the hard drives have different ID numbers (boot drive
should have lowest ID).

•

Make sure both ends of the SCSI bus are terminated. Termination
should only be at the ends of the bus.

•

Check all cable and power connections.

•

Boot the system.

6.5 About the SYMCD.SYS Driver

This section describes the characteristics of the

SYMCD.SYS

driver and

provides installation instructions:

6.5.1 Features

The

SYMCD.SYS

driver supports these features:

•

Compatible with the Microsoft CD-ROM Extension 2.21 and above

•

Multisession Photo CD support

•

Up to eight host adapters

6.5.2 Description

The

SYMCD.SYS

device driver is needed whenever a CD-ROM device is

connected on the SCSI bus. You must load it in conjunction with the
Microsoft CD-ROM Extension 2.21 or above (

MSCDEX.EXE

).

The

SYMCD.SYS

driver communicates through

ASPI8XX.SYS

. To use the

SYMCD.SYS

driver, you must also load

ASPI8XX.SYS

.

Advertising
This manual is related to the following products: