Avago Technologies LSI20160 - Manual (Page 242)

12-8 NetWare Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
The system prompts you with the limited available command
line options for loading the driver. A description of each option
appears in the box at the bottom of the installation screen. A
more detailed description is also available in
Section 12.4,
“Using the Command Line Options,” page 12-9 .
Step 4. Modify any option values as needed for this installation.
Step 5. Load a separate instance of the driver for every LSI Logic
controller SCSI channel or host adapter present in the system.
Step 6. Accept the slot numbers displayed when prompted for a slot
number. Make sure to write these slot numbers down for use in
Step 8.
Step 7. Edit the STARTUP.NCF file when the system prompts you to do
so. Make sure the LSI8XXNW.HAM , LSIHINW.HAM , or
LSI_U3NW.HAM is loaded once per LSI Logic controller SCSI
channel present in the system.
Step 8. Add the statement SLOT=<slot number> to each load line in
the STARTUP.NCF , specifying the slot numbers written down in
Step 6 with only one slot number per load instance.
The system loads the HAM driver(s) for each LSI Logic controller
SCSI channel from the first LOAD statement to the last LOAD
statement.
12.3.3 Upgrading to Symmetric Multiprocessing (SMP)
To upgrade to SMP after NetWare version 4.XX has been installed, follow
these steps:
Step 1. Type at the server prompt:
load install
A menu appears.
Step 2. Select Multiprocessor .
Another menu appears.
Step 3. Select the default: MPS14 .
Step 4. Follow the remaining prompts and then exit from the Install
Menu.
Step 5. Shut down the server and reboot the system.
Note: Other third party CDMs may also support these devices.