Avago Technologies LSI20160 - Manual (Page 218)

10-12 Solaris Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
Do you want to create a new instance of this package [y,
n, ?, q]
Step 7. Type n for No.
If you specify yes, then this message appears:
Do you want to overwrite this installed instance?
Step 8. Type y for Yes to overwrite the old driver.
Step 9. Unmount the diskette when the installation has completed and
the
install.sh script exits by typing at the command prompt:
# cd
# umount /mnt
Step 10. Remove the Solaris Driver ITU diskette from the diskette drive.
Step 11. Reboot your machine by typing at the command prompt:
# touch /reconfigure
# reboot
Step 12. If you have not already done so, turn off your system, add the
new hardware, and turn on your system again.
Step 13. At the <<Current Boot Parameters >> prompt, type:
b -r
to force reconfiguration of the machine.
When the Solaris operating environment is finished booting and running,
the new devices whose drivers that you installed are available for use. To
verify the version number for the Solaris 7 or Solaris 8
symhisl driver,
type at the prompt:
# modinfo | grep sym
After entering this command, the system will display the version number.
10.4 Troubleshooting
The Solaris operating system may display some informational or potential
error messages that may be preceded by a warning message. In the
message descriptions below, the
SYMHISL<n> signifies that <n> can be
replaced by a number assigned to it by the operating system. That value