Avago Technologies LSI20160 - Manual (Page 219)

Troubleshooting 10-13
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
helps to identify the SCSI bus that is reporting the error. The <s> and
<x> marks are placeholders for strings and numbers that the system will
display.
SYMHISL<n>: This hardware not supported by this driver
The symhisl driver has been told to control an LSI53C895A, LSI53C896,
LSI53C1000, or LSI53C1010 controller. If the hardware is made by a
manufacturer other than LSI Logic Corporation, this adapter requires a
special driver provided by that manufacturer. Please contact the
manufacturer for assistance. If the hardware is an older LSI Logic host
adapter board, contact Technical Support at 719-533-7230 and talk with
a technician.
SYMHISL<n>: Failed to map device registers
The symhisl driver was unable to access the hardware registers
necessary for operation. The operating system did not properly configure
the PCI device.
SYMHISL<n>: NVS error, failed to restore value of 'reg'
property
The symhisl driver was able to access the resources needed to
determine NVS configuration but was not able to return the system to its
prior state. Further configuration errors may occur.
SYMHISL<n>: NVS error, failed to map system memory. NVS data
cannot be used.
SYMHISL<n>: NVS error, failed to update 'reg' property. NVS
data cannot be used.
SYMHISL<n>: NVS error, failed to allocate memory. NVS data
cannot be used.
SYMHISL<n>: NVS error, unable to find 'reg' property. NVS
data cannot be used.
For each of the above errors, the symhisl driver was not able to access
NVS configuration data to see if it exists. On some systems, this will not
be a problem. On other systems however, NVS data contains the
configuration information for this adapter and the
symhisl driver is not
able to use that configuration. This may cause you to manually configure
the driver using the
symhisl.conf configuration file. Please refer to the
man page driver.conf (4) , which is the standard reference on how to