Avago Technologies LSI20160 - Manual (Page 192)

8-12 SCO OpenServer 5 Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
Step 2. Select option 1 to install a tape drive, and press Enter.
The Tape Drive Installation menu appears.
Step 3. Select option 1 to install a SCSI tape drive, and press Enter.
The system prompts for the identifier of the host adapter that
supports this device.
Step 4. Press Enter if the default is correct. If the default is not correct,
type:
slha
Press Enter.
The system prompts for the host adapter that supports the tape
drive.
Step 5. Type the correct host adapter number, and press Enter.
If an additional LSI Logic host adapter is being added to the
SCO OpenServer kernel, the system may prompt if you want to
update the link-kit (add another host adapter).
Type y and press Enter if you entered the host adapter number
correctly;
or
Type n and press Enter, if you entered the host adapter
number incorrectly. The system then prompts for the host
adapter identifier of the preceding step.
The system prompts for the SCSI bus number of the tape drive.
LSI Logic host adapters support one bus per adapter.
Step 6. Press Enter to get the default of zero or type 0 (zero) and press
Enter.
Note that dual channel devices appear as two host adapters.
The system prompts for the SCSI ID of the tape drive.
Step 7. Type the SCSI ID number of the tape drive and press Enter.
The system prompts for the LUN of the tape drive.
Step 8. Type 0 (zero) and press Enter.
The system then prompts to update the SCSI Configuration file.
Step 9. Type y and press Enter.
The system prompts for a “Vendor Identification” string.