Avago Technologies LSI20160 - Manual (Page 197)

Troubleshooting 8-17
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
8.4 Troubleshooting
Some potential problems and their suggested solutions are:
Loading SCO UNIX to an IDE hard drive.
You only need to link if you have a SCSI device attached to an LSI Logic
host adapter. Follow the instructions in the SCO UNIX Installation
documentation. Once the installation has completed, go to Step
1 in
Section 8.3.2, “Existing System Installation,” and use the installpkg to
install your SDMS driver.
A SCSI device is not found.
•
Reboot and press Ctrl-C to view the SCSI BIOS Configuration
Utility.
•
Verify the device is on the correct host adapter and ID.
•
If the device is not shown, then it is probably turned off or a cabling
problem exists.
UNIX system behaves unreliably after a configuration change.
Whenever the hardware or software configuration is altered, you must
rebuild the kernel. Go to the directory
/etc/conf/cf.d and type:
./link_unix
to rebuild the kernel.
An error message occurs during the rebuild of the kernel.
•
Reinstall the proper SDMS driver using the installpkg utility.
Remember to relink the kernel.
•
Reboot the system.