PLANET BSP-300 - Manual (Page 7)

7
Step 2. Install battery
Battery
DC
DC
1
2
Bat. In/Out
(1) Connect the negative electrode of the battery to the terminal for the negative
electrode of the battery on the BSP-300.
(2) Connect the positive electrode of the battery to the terminal for the positive
electrode of the battery on the BSP-300.
(3) After the battery is well connected to the BSP-300, the System LED will ON
with slow blinking for system ready and the Fault LED will slow blinking for PV
not connected.
Note
Be noted for the thickness of electric wire and please refer to l
the section - Recommended Use of the Connection Wires of
the user manual.
The BSP-300 accepts l DC 24V battery system, please pay atten-
tion to the battery characteristics and also refer to the section
- Recommended Settings for Different Batteries of the user
manual.
Check the total power consumption of your connected network l
device before installation. Improper battery capacity could
shorten the battery life or make your network device lack of
power supply.