PLANET BSP-300 - Manual (Page 8)

8
Step 3. Install PV panel
Solar PV
DC
DC
1
2
PV In
(1) Connect the negative electrode of the PV panel to the terminal for the
negative electrode of the PV panel on the BSP-300.
(2) Connect the positive electrode to the terminal for the positive electrode of the
PV panel on the BSP-300.
(3) After the PV is well connected to the BSP-300 and providing 24V or above
voltage, the System LED will fast blinking for battery charge if the battery is
not full. And turn off the fault LED.
Note
Be noted for the thickness of electric wire and please refer to l
the section - Recommended Use of the Connection Wires of
the user manual.
The BSP-300 supports maximum l 45V DC input, please refer to
the Specification of the user manual before installation.
Check the total power consumption of your device and the l
sunshine duration of your area from weather bureau for a
proper PV. Improper PV could shorten the battery life or provide
insufficient power to BSP-300.