PLANET ICA-8350 - Manual (Page 58)

3Mega-Pixel Vandal Proof Fish-Eye IP Camera
ICA-8350
58
Default Settings
(Include the network
setting) Recall the device hard factory default settings. Note that click
this button will reset all device’s parameters to the factory
settings (including the IP address).
Default Settings
(Except the network
setting) The unit is restarted and most current settings are reset to
factory default values. This action will not reset the network
setting.
Backup Setting To take a backup of all of the parameters, click this button. If
necessary, it will then be possible to return to the previous
settings, if settings are changed and there is unexpected
behavior.
Restore Setting Click the “Browse” button to locate the saved backup file and
then click the “Restore Setting” button. The settings will be
restored to the previous configuration.
Firmware upgrade The device supports new firmware upgrade.
1. Close all other application programs which are not necessary for firmware
update.
2. Make sure that only you access this device at this moment
3. Disable Motion Detection function.
4. Select “Firmware name”
5. Select the Firmware binary file.
Note :
That it must make sure that the Firmware only applies to this device,
once update, it will be burned into FLASH ROM of system.
6. Once the firmware file was selected, select “Upgrade”.
7. The upgrade progress information will be displayed on the screen.
8. A message will be shown while the firmware upgraded. Once the upgrading
process completed, the device will reboot the system automatically.
9. Please wait for 80 seconds, and then you can use PLANET IP Wizard II to
search the device again.
Warning!!!
The download firmware procedure cannot be interrupted. If the power and/or
network connection are broken during the download procedure, it might
possibly cause serious damage to the device.
Please be aware that you should not turn off the power during updating the
firmware and wait for finish message.
Furthermore, do not try to upgrade new firmware if it’s not necessary.
System Restart The device is restarted without changing any of the settings.