PLANET IPOE-E174 - Manual (Page 14)

14
2.3 Mounting Installation
This section describes how to install the Industrial Power over Ethernet
Extender and make connections to it. Please read the following topics
and perform the procedures in the order being presented.
Note
In the installation steps below, this Manual uses IGS-801
(PLANET 8 Port Industrial Gigabit Switch) as an example.
However, the steps for PLANET Industrial Power over
Ethernet Extender are similar.
2.3.1 DIN-rail Mounting
Place the Industrial Power over Ethernet Extender on the DIN rail,
which is mounted on the wall, and screw it. Just follow the steps below
to install the Extender.
Step 1: Lightly insert the bottom of the switch into the track.
2
1
Step 2: Check if the DIN rail is tightly on the track.