PLANET WAP-6100 - Manual (Page 18)

Operation Mode The default operation mode is Access Point; this mode connects your
wireless clients to a wired network. In most cases, no change is necessary.
You can switch operation mode to Wireless Client, Repeater or Wireless
Bridge mode depends on your application. Wireless Client mode can allow
AP act as a client within its range. Your Ethernet devices behind the AP client
can connect to a remote AP. Repeater is able to retransmit the signal of a
remote AP. Choose repeater mode if you want to extend the range of your
original AP. Wireless Bridge mode allow you to create a wireless connection
to connect the networks between different building. You may check to the
section 4.2/4.3 and 4.4 for more details of those operating mode.
4.1.4 Administration
Administrator Name You change the administrator login name in this field.
Password Type the new password here if you need to change it.
Confirm Password Re-type the new password again, then click the “Apply” below to save the
changes.