PLANET WNAP-6300 - Manual (Page 26)

3.4 Basic System Settings
For users who use the WNAP-6300 for the first time, it is recommended that you begin configuration
from “Basic Settings” in “System” shown below:
Figure 14 Basic System Settings
Basic Settings
Network Mode: Specify the network mode, including Bridge and Router. It is easy to configure
parameters in Bridge Mode; however, users must pay extra attention to the way they configure the
device when it is set to Router Mode. For details, please refer to “IP Settings (Router)”.
Device Name: Specify the device name, which is composed of no more than 15 characters with
(0-9), (A-Z), (a-z) or (-).
Country Region: The availability of some specific channels and/or operational frequency bands
is country dependent.
IP Settings (Bridge)
This is available only under Bridge network mode. Open “IP Settings (Bridge)” in “System” as
below to configure the parameters for LAN which connects to the LAN port of WNAP-6300. In this
page, users may change the settings for IP Address, Subnet Mask, and DHCP Server.
Chapter 3 Basic Settings Page 17