PLANET WNAP-6300 - Manual (Page 28)

Figure 16 IP Settings (Router)
WAN Settings: Specify the Internet access method to Static IP, DHCP or PPPOE. Users must
enter WAN IP Address, Subnet Mask, Gateway settings provided by your ISPs.
LAN Settings: When DHCP Server is disabled, users can specify IP address and subnet mask
for WNAP-6300 manually. Make sure the specified IP address is unique on your network in order
to prevent IP conflict. When DHCP Server is enabled, users may specify DHCP IP Address Range,
DHCP Subnet Mask, DHCP Gateway and Lease Time (15-44640 minutes).
In wireless AP mode, WNAP-6300 must establish connection with another wireless
device before it is set to Router mode. In system network Router mode, it is
impossible for users to access device via wired port, for WAN is on wired port and LAN
is on wireless port. Users can access device through the wireless device connected
with WNAP-6300.
In wireless CPE mode, users can access WNAP-6300 via its wired port, for WAN is on
Warning:
Chapter 3 Basic Settings Page 19