PLANET ADN-4100 - Manual (Page 41)

3.2.4
17B
Local Network
You can configure the LAN IP address according to the actual application. The
preset IP address is 192.168.1.1. You can use the default settings and DHCP
service to manage the IP settings of the private network. The IP address of the
device is the base address used for DHCP. To use the device for DHCP in your
LAN, the IP address pool used for DHCP must be compatible with the IP address
of the device. The IP address available in the DHCP IP address pool changes
automatically if the IP address of the device changes.
You can also enable the secondary LAN IP address. The primary and the
secondary LAN IP addresses must be in different network segments.
Choose Setup > Local Network. The Local Network page as shown in the
following figure appears:
30
By default, Enable DHCP Server is selected for the LAN interface of the device.
DHCP service provides IP settings to workstations configured to automatically
obtain IP settings that are connected to the device through the Ethernet port.
When the device is used for DHCP, it becomes the default gateway for DHCP
client connected to it. If you change the IP address of the device, you must also
change the range of IP addresses in the pool used for DHCP on the LAN. The IP